There is an erroneous opinion that the gas stove for a bath does not allow to fully feel the specific atmosphere that should prevail in the steam room. However, in fact, in addition to the use of alternative fuels, everything remains the same.

The advantages of gas stoves for a bath

Gas sauna stove: key benefits, installation tipsWithout a doubt, firewood is the best option when there are no problems with their prey. Otherwise, a gas stove for a bath can come to the rescue, the operation of which is accompanied by economical consumption and low fuel costs.

Among other advantages of units in this category, it is worth noting:

  • Modest dimensions.
  • The possibility of fine adjustment of the indoor climate.
  • Easy operation.
  • No need for meticulous care.

Due to what gas units function so effectively? The burner of the stove for a bath is the main and most complex element here. The overall operational safety of the unit depends on its stable operation.

A modern gas stove for a bath may contain a pressurized or atmospheric burner. The first are extremely effective because they have a system of compulsory hot air. The indisputable advantage of supercharged burners is a special stability of operation and economical fuel consumption. The disadvantage can be considered relatively noisy operation and dependence on power supply.

As for atmospheric burners, the device of such units is extremely simple. The flow of air into the combustion chamber is based on the principle of thrust. The gas stove for a bath with an atmospheric burner does not need to be connected to the mains, it is notable for quiet operation, efficient operation at the lowest gas pressure indicators.

How to install a stove in the bath?

Installation of this unit in the steam room requires an extremely responsible attitude. Subsequently the quality of the installation will depend on the safety of operation, efficiency of heating.

In order not to be puzzled once again by finding the answer to the question of how to install a stove in a bath, it is better to resort to the help of qualified craftsmen. If it is decided to carry out installation work on his own, you should pay attention to the following points:

  1. When selecting the place for installation it is necessary to maintain a distance between the walls and the furnace is not less than 0.5 m. In this case, all structures around the unit are made of non-combustible materials.
  2. The basis on which you are installing the gas heater for the bath should be at least 10 cm from the Assembly around its perimeter.
  3. The opening under the burner must conform to the following parameters: the height of 47-55 cm, width from 35 to 45 cm.
  4. Flexible connections should be used resistant to high temperature and pressure pipes with a diameter of at least 10 mm.
  5. Before the furnace, a dense metal sheet with a substrate in the form of a heat-insulating layer must first be laid.

Widely demanded gas stoves for the bath “Termofor”, like other popular models, are connected to the chimney with stainless steel pipes. During installation, the latter should move into each other at a distance that is equal to half of their diameter.

The stove is installed on the front side of the waiting room, where exhaust ventilation is organized and, additionally, an outlet with a vent is installed, which will allow the gas to be removed from the premises in case of an emergency. It is extremely important that the connection of the chimney with the stove is distinguished by maximum tightness.

How to efficiently install a gas furnace in the regeneration bath? As practice shows, these units are much easier to operate and easier to maintain compared to traditional wood structures. System on gas will be a highly effective option not only for baths but also for the sauna. Currently this solution seems the most economical.

However, when installing a gas stove in an independent manner in a bathhouse, it is worthwhile to take the safety requirements seriously, having received the appropriate permission from state institutions. Compliance with the technology of installation and operating rules contributes to the smooth operation of the furnace for many years.

Interesting: